BP ASP 5 K ULTRA O/SN

Home / ecology / BP ASP 5 K ULTRA O/SN
View basket “Home sewer inspection connection” has been added to your basket.
BP ASP 5

50,882.50kn

BP ASP 5 K ULTRA O/SN

for wastewater treatment of family houses from 3 to 7 ES (population equivalent)

The sizing of biological wastewater treatment plants BP ASP K ULTRA was performed in accordance with HRN EN 12566-3 and HRN EN 12255 so that 1 ES consumption of 150 l / day of water and BOD5 of 60 g / day is foreseen.

There are no reviews yet.

Be the first to review “BP ASP 5 K ULTRA O/SN”

Category: .

DESCRIPTION OF DEVICE OPERATION

Wastewater enters the primary sedimentation tank which at the same time serves as a tank for excess sludge. Sedimenting and floating substances prevent further passage and are subjected to anaerobic digestion. The mechanically treated water is poured into the activation part where the microfiltration module is located. The activation part is used for biological treatment and microfiltration through membranes. At the bottom of this part are placed aerators that are used for aeration of the tank and cleaning of the membrane, and the air is supplied by a blower.

The advantage of this type of purifier BP ASP K ULTRA is the accumulation part within the entire activation tank used to collect wastewater and solids from the purifier.

The activated sludge mixture is filtered under pressure through a membrane. In case the microfiltration module is not in operation, the mixture is poured into a vertical secondary precipitator where sludge accumulates and precipitates and subsequently purified water flows out. Concentrated sludge from the bottom of the secondary precipitator is returned to the primary precipitator. Part of the activated sludge from the activation part is pumped as excess into the primary precipitator.

Advantages of devices compared to other types of devices for biological wastewater treatment:

  • The device is easy to install.

  • In practice, the sludge is extracted once at intervals of 6 months to 2 years.

  • Device maintenance consists of a person visiting the device once a week and checking the operation of the device.

  1. – If all parameters are met, the device does not emit unpleasant odors

  2. – There are no moving parts on the device, so there is practically nothing to break but the compressor, which needs to be maintained in accordance with the instructions.

  3. – No need to add bioactivators which reduces the cost of maintenance

METHOD OF INSTALLATION OF ROUND DEVICES (O)

Installation of devices with a single wall type «SN»

(Green surface, soil layer on the device max 30 cm, no additional loads)

It is necessary to excavate approximately 40 cm wider than the specified dimensions of the device. A tampon layer of gravel or sand 15-20 cm thick is placed on the bottom of the excavation. A reinforced concrete slab 20-25 cm thick is placed over it. Concrete class, arrangement and dimensions of reinforcement are determined depending on the planned load, demanding load-bearing capacity, geomechanical and hydro-geological conditions. The device can now be placed in the middle of the excavation and connected to the inlet and outlet piping. The device must be gradually filled with water in layers of up to 30 cm and the space between the device and the excavation covered with moist sand with compaction (the device must remain full of water).